Guest
👉 Hi all! The basic tutorial of installing CB1&M4P is released!Let’s check what the instruction is ! ⏰ Timestamps: Unboxing & Introduction: 00:00 Mainboard wiring: 02:27 Firmware Installation: 03:57 Test & Print: 11:05 The Manta - M4P motherboard is 𝐅𝐑𝐄𝐒𝐇! ✅ Supports both Klipper and Marlin,3 PWM fan ports and 1 SoC fan port ✅ SPI port for interfacing with an ADXL345 accelerometer ✅ On-board EEPROM for configuring Marlin ✅ Supports the shutdown after printing function, filament runout detection, BL Touch and RGB lighting ✅ DSI & CSI interfaces available for using a CM4 ✅ 40 pin GPIO headers and BTB (Board to Board) design makes the M4P perfectly compatible with either the CM4 or the BIGTREETECH CB1 ✅ Blazing fast on-board processor: STM32GOB0RE 32-bit ARM Cortex-M0 @64MHz ✅ Equipped with 4pcs motor drivers interfaces:X,Y,Z(Dual
