Myvideo

Guest

Login

STM32 Programming via USB (DFU) - Phil's Lab #72

Uploaded By: Myvideo
1 view
0
0 votes
0

How to flash firmware via USB to STM32 devices via DFU (device firmware upgrade) and STM32 Cube Programmer. This way you do not need an ST-Link or similar programmer to flash firmware - however, you cannot set breakpoints, debug, and so on. Note: this is only supported on certain STM32 microcontrollers (check the datasheet!). Tag-Connect SWD Probe: [SUPPORT] Free trial of Altium Designer: PCBA from $0 (Free Setup, Free Stencil): Patreon: Mixed-signal hardware design course: [GIT] [TIMESTAMPS] 00:00 Introduction 00:24 Altium Designer Free Trial 00:43 JLCPCB and Git Repo 01:08 STM32 DFU Overview 01:58 Test Firmware 02:38 Generating Binaries 03:19 STM32CubeProgrammer and Flashing (BOOT0=1) 04:37 Run Mode (BOOT0=0) ID: QIBvbJtYjWuHiTG0uCoK

Share with your friends

Link:

Embed:

Video Size:

Custom size:

x

Add to Playlist:

Favorites
My Playlist
Watch Later