Setting Up BTT ADXL345 & S2DW Accelerometers with Klipper

This video is going to show you how to set up the bigtreetech S2DW and ADXL345 accelerometers on klipper. Don't worry it's super easy too. Check out this video's sponsor PCBway - ** Affiliate links to help the channel out ** ADXL345 V2 - LIS2DW (S2DW V1) - BTT Pi - All the Bigtreetech and BIQU stuff to mod your 3D printer - 00:00 - intro 05:12 - start the install - 08:44 - configure the firmware 11:51 - compile the firmware 12:21 - connect device in boot mode. 13:23 - confirm the device is in boot mode 13:56 - flash the firmware 16:54 - get the serial for the new device 19:03 - Thank you PCBway!!! 20:17 - set-up the configuration LIS2DW v1 - ADXL345 v2 - 22:55 - set your axis map! 32:24 - Don't forget the the stuff you need in the 34:23 - confirm the sensor is up and running. ACCELEROMETER_QUERY 35:05 - install the sensor 36:43 - let's get ready to run the test 39:09 - run the auto calibrate #input-shaper-auto-calibration 44:14 - SAVE_CONFIG 45:41 - what to do when you are done 46:42 - what's this Bonus?? Check out AccelFlasher -