AMAZING DIY Pitts S12 Full Build and Flight

STL Files: LW-PLA: Thank you so much for watching! If you like videos like this, consider buying me a coffee, it really supports me: See what else I am working on: @troymcmillan_rc?lang=en #3DPrinted,#RCAirplane, #ItFlies Pitts S12 Parts: SunnySky 2820 1100kv Motor: 11x5.5 APC prop: 60A ESC: ES08MA Servo: 3S 2700mAh Battery: 4S 2200mAh Battery: 2x8mm Screws: 10x5x3 Magnets: 1/8” Wheel Collar: 3pin wire assortment: XT60 connector: 2mm push rod ends: 3D Printers I use and recommend: AnyCubic Vyper: Artillery Sidewinder 3D Printer: Artillery Genius 3D Printer: Ender3 V2: Twotrees Sapphire-PRO: Anycubic Mega X Printer: Fokoos Odin-5: 3D Printing Filament: ABS for motor mounts: ColorFabb LW-PLA: ePLA-ST: TPU: Tools and Supplies used: Spektrum DX6 Controller: Spektrum NX10 Controller: Receiver: Battery Charger: Charge cable: XT60 connector: Assortment of 3-Pin Extension Cables: Z-Bend pliers: 2mm push rod ends: CA Glue: CA Accelerator: Low-Voltage Tester: Hot knife: Drill Bits: Hobby Knife: #11 blades: Z-Bend pliers: Build Mat: Onboard Camera: Lead weight: Print Settings: Quality: Layer Height – Initial Layer Height - Line Width – 0.4 Walls: Wall Line Count – 1 Z Seam Alignment - User Specified Z Seam Position - Back (Position part to align Z seam) Seam Corner Preference - Expose Seam Top/Bottom: Top Layers - 0 Bottom Layers - 0 Infill: Infill Density – 0 Material: Printing Temperature – 235 Build Plate Temperature – 60 Flow – 55% Speed: Print Speed – 100 Outer Wall Speed – 55 Inner Wall Speed – 55 Travel Speed – 120 Travel: Enable Retraction – Checked Retraction Distance – (Bowden Tube Ender3) Retraction Speed – 35mm/s Retraction Extra Prime Amount – 0.2 Combing Mode – off Cooling: Enable Print Cooling – Checked Fan Speed – 80 Mesh Fixes: Union Overlapping Volumes – Checked Special Modes: Surface Mode – Normal Experimental: Slicing Tolerance – Middle Music: Song: Jarico - Landscape (Vlog No Copyright Music) Music promoted by Vlog No Copyright Music. Video Link: Music: Joakim Karud: YouTube: Soundcloud: Music provided by Argofox: From The Dust - Solar Music provided by Argofox: Ghost'n'Ghost - Lighthouse Disclaimer: I am sponsored by some of the products I mention. However, all of my opinions are my own. Some of the above links are affiliate links, that does not effect the price you pay for a product, but I may receive a small commission if you make a purchase. This helps support my channel and allows me to continue to make videos like this. Thank you for your support!!