Altium STM32 Hardware Design - An Overview in Under 20 Minutes - Phils Lab #38

Overview of how to design an STM32-based PCB including various peripherals (SD card, USB) and some sensors (IMU and barometric pressure sensor). Including information on how to order these PCBs fully-assembled from JLCPCB. This board will be used in future videos on signal processing, STM32 firmware, and more - and is an upgrade on the original ’LittleBrain’ PCB. Hardware designed using Altium Designer. [SUPPORT] Free trial of Altium Designer: PCBA from $0 (Free Setup, Free Stencil): Patreon: [LINKS] Git: [TIMESTAMPS] 00:00 Introduction 00:21 LittleBrain (LittleBrain PCB Update) 00:50 JLCPCB and Git Repo Design Files 01:32 Altium Designer Free Trial 01:45 Schematic Overview 02:04 Power Supply Schematic 04:20 STM32 Microcontroller 06:25 Pin Assignment with STM32CubeIDE 08:15 Serial Wire Debug (SWD) 08:55 USB 09:05 SD Card 09:39 GPIO Header 09:58 Sensors (IMU and Pressure Sensor) 11:26 PCB Overview 11:52 Layer Stackup and Impedances 12:51 Power Supply Layout and Routing 13:22 STM32 Layout and Routing 14:09 SDIO and USB Interfaces 14:34 Sensors Layout and Routing 14:56 Ground and Stitching Vias 15:29 Silkscreen 15:38 Design Rule Check, Gerber and Assembly Files 16:33 Ordering at JLCPCB ID: QIBvbJtYjWuHiTG0uCoK