Guest
Wood: walnut, maple, Osage Orange How to find inlay parameters. Feed rate v bit 30ipm 👍👍👍 Feed rate flat nose 1/8 40ipm 👍👍👍 For orders go to Check out our Instagram page email: broinwood@ 🔥🔥🔥Here some stuff which I use in my workshop and really love it. Maybe it will be useful for you.🔥🔥🔥 Definitely recommend this Oil and Wax for cutting board: My glue: (really love it) Double-Sided Duct Tape:👍👍👍 (It holds blank well, but anyway, I also use screws.) My Random Orbit Sanders I love how they work but they get a little dusty: Makita 3/4-Inch ID/1-OD diameter by 10-Foot Hose My Sanding Disc (for me they are the best!!!): 3M Cubitron II (80 and 120 grit) (150 grit) (220 grit) (320 grit) My router bits which I use a lot: My favorite router bit!!!: Metric CNC 2D and 3D Carving 6.2 Deg Tapered Angle Ball Nose (clean cut, long life, definitely recommend) 👍👍👍 2D & 3D Carving 12.4 Deg Tapered Angle Ball Tip x 1/32 Dia x 1/64 (clean cut, long life, definitely recommend) Standard Spiral Bit with Down Cut 1/8-Inch Cutting Diameter 15 Degree v bit (be careful easy to break down) Round Nose Bit with 3/8-Inch Radius, 3/4-Inch Cutting Diameter and 1-1/4-Inch Cutting Length (I use it for juice groove) 1/2-Inch Dia. 2 Flute Ball Nose Spiral End Mill Router Bit (I use it for juice groove) Spiral Flush Trim Bit with Down Cut and 1/2-Inch Cutting Diameter Three Flute with Spiral Bit 1/2-Inch Cutting Diameter and 2-Inch Cutting Length (I use it for flatining surface and makining cutting board shape) Spiral Bit with Up Cut 1/4-Inch Cutting Diameter and 1-Inch Cutting Length (I use it for cut off inlays. it doesn't make chips.) My Collet Set: My DEWALT Plate Joiner: (it is not bad and not good it is ok) My Bandsaw Blade it is inexpensive and cut well: Hi, My name is Nik. Welcome to my channel! I appreciate your likes and subscriptions! Sincerely, Nik.
