Guest
Description #StarWars #Vader #Tutorial A few months ago, I made a book nook featuring Vader in the hallway from Rogue One. I used an LED filament from a high voltage lightbulb to create the lit lightsaber effect. This is obviously quite dangerous so I waited until I had a safer, low voltage option to put out a tutorial for you all. Many of you asked, so here it is. Thanks for your patience! I hope you enjoy and go on to make little lightsabers to your heart’s content. These lightsabers are at the 1:12 scale which will fit with Bandai figure kits and 6” Hasbro Black Series figures. If you have any questions, let me know in the comments and I’ll help how I can! My other Vader Build: Materials: Bandai 1:12 Darth Vader 3V LED Filaments (130mm) LED Tape Slotted Aluminum Sheet Opaque Acrylic Sheet Solder Heat Shrink Tubing Copper Wire Plastic Cement Super Glue Masking Tape .040 Styrene .020 Styrene Old Frame (Thrift Store Find) Supplies: Safety Glasses Hand Drill/Pin Vice X-Acto Z Series Utility Knife Ruler Nippers Wire Cutters Tweezers Paint Brushes Helping Hands Soldering Iron Paint: Rust Olium Flat Black Music: Autumn Wind - Dyalla Nobody Home - Dyalla Le Freak - Rage Giant iPhone - Rage Disclaimer: Some of the actions seen in my videos could cause bodily harm. I am not responsible for anything you do while attempting to recreate what you see me do. Amazon Affiliate links are used above.
