Here’s how i tuned my Elegoo neptune 4 and 4 pro machines. I hope this helps get you started on your klipper journey, if you have any questions or tips i dont mention here feel free to leave a comment below. Check out todays video sponsor @ElegooOfficial here: (affiliate link) COMMANDS: Run the mesh bed leveling - BED_MESH_CALIBRATE Enable temperature tower - TUNING_TOWER COMMAND='SET_HEATER_TEMPERATURE HEATER=extruder' PARAMETER=TARGET START=200 STEP_DELTA=5 STEP_HEIGHT=5 Run PID tuning Hotend - PID_CALIBRATE HEATER=extruder TARGET=230 Bed - PID_CALIBRATE HEATER=heater_bed TARGET=65 PID value should be formatted this way under the extruder and heater_bed sections: control :pid pid_kp : pid_ki : pid_kd : Pressure advance Run this command first - SET_VELOCITY_LIMIT SQUARE_CORNER_VELOCITY=1 ACCEL=500 Then this command - TUNING_TOWER COMMAND=SET_PRESSURE_ADVANCE PARAMETER=ADVANCE START=0 FACTOR=.005 Pressure advance model can be found here: #elegoo #neptune4pro #3dprinting
Hide player controls
Hide resume playing